Related Articles
PowerShell – Hash Table Get That Value
Posted on Author stefanroth
When writing scripts I like to use PowerShell ISE or VSCode a lot. It simplifies a lot of your daily scripting tasks like IntelliSense or Snippets. But sometimes these little helper don’t tell always the truth. Why? Well, I show you an example which is quite common. On problem there is if you are working […]
OMS – Custom Solution “SCOM Effective Configuration”
Posted on Author stefanroth
I had been very busy lately so this blog has been quite for few days, but now I would like to provide a custom OMS solution. My goal was to build a solution which shows you the effective configuration of a monitor or rule, based on a group of objects in SCOM. I created two […]
SCOM 2012 – NetApp MP 3.1 Error 1923 (VIM_Service)
Posted on Author stefanroth
If you are going to setup the NetApp OnCommand Plug-in 3.1 as I posted here there is a chance that you run into an “Error 1923Service OnCommand Virtual Infrastructure Management Service (VIM_Service) could not be installed. Verify that you have sufficient privileges to install system services.”